Filtration Systems
Cartridge, sand and DE filters supplied and installed, sized to your pool volume with the right media and a clean manifold.
Most equipment problems start on the day the equipment went in. A filter that is too small for the pool, a pump that is oversized for the plumbing, unions that were never aligned, and you spend the next decade chasing pressure and noise. We install filtration systems and pumps as one matched system, sized to your pool volume and turnover.
Old pad, new pool or a piece of equipment that finally gave up, we handle the whole job, including new plumbing, valves, unions and the electrical hookup. Serving Seattle, Bellevue, Kirkland, Renton and the entire Puget Sound area.
One crew for the whole pad, so the filter, the pump and the plumbing are matched instead of pieced together.
Cartridge, sand and DE filters supplied and installed, sized to your pool volume with the right media and a clean manifold.
New and replacement pumps, including quiet variable speed models that cut running costs and pair with automation.
Tired pad rebuilt from the ground up, new plumbing, valves, unions and a layout that is actually serviceable.
Gas heaters and heat pumps installed alongside the filter and pump so the whole system is tuned together.
Salt chlorine generators and cells installed and set up, including full conversions from traditional chlorine.
Smart controls wired in and programmed so your new pump, heat and lights run themselves from your phone.
It depends on the size of your pool, the equipment you choose and the shape of the existing plumbing and electrical. Most filter and pump installations fall in a predictable range, and we give a clear written quote after looking at your equipment pad. Call (206) 202 1454 for a free quote.
Filter size is based on your pool volume and the turnover rate you want, and it should always be matched to the pump. An undersized filter clogs constantly and an oversized pump pushes water through too fast to filter well. We calculate both together so the system runs efficiently.
Cartridge filters are the most common choice for Seattle backyards, they filter fine and use no backwash water. Sand is the lowest maintenance and easiest to live with. DE filters give the clearest water but need more upkeep. We walk you through the trade offs before anything is ordered.
For most pools, yes. Variable speed pumps run quieter, use far less electricity at low speed and often pay for themselves in energy savings within a few seasons. They also pair well with automation if you want to control the pool from your phone.
A straight filter or pump swap is usually a single day. A full equipment pad rebuild with new plumbing, a heater and electrical work typically takes two to three days, and we tell you up front how long your pool will be down.
Yes. We install and replace spa pumps, filters, heaters and control packs on portable and in ground hot tubs, swim spas and cold plunges across the Seattle area.
Already have equipment that just needs attention? See filter service, pump repair or the full list of pool and hot tub services.
Free quotes, fast answers, and a real person on the other end.